5. EQUALIZER
Adjust low, high if EQ volume according to condition.
6. MASTER 1 & 2 CONTROLS
This is master volume for all input levels you and better use toward two o clock adjust level before clipping for proper operation.
7. POWER SWITCH
Press to turn ON the power. Press again to turn the power OFF.
REAR PANEL :
8. AC
CORD
Be sure to check AC voltage. Use fuse approved.
IMPORTANT NOTICE : Be sure not to make a shorten for battery and polarity of battery.
9. DC SOCKET
This is a connector unexpected AC Failure. 24V DC
10. MASTER 1 & 2 OUPUTS
This is master outputs which can be selected by switch.
11. REC OUTPUT
Recording outputs two L, R unbalanced RCA jacks are converted into stereo signals in the internal circuit from mono signal. Recording
output volume can not be controlled by master volume controller because circuit of recording output controls is just in the before master
volume controls.
12. 7 TO 10 INPUTS
LINE 7~10 unbalanced two L, R RCA jack are converted into mono in the internal circuit all line input 10dB(245mV) input level are for
cassette deck, CD, dat deck, tuner.
13. 2 TO 6 INPUTS
MIC/LINE balanced input can be selected by mode switch in the front panel.
IMPORTAN NOTICE :
When you select MIC input, operating voltage is only for condensor microphone if you connect dynamic microphone
balance by mistake, microphone will be out of work also, be sure not be insert mic input connector under level volume-up, speaker systems
may get damage due to big noise.
14. PTT1 INPUT
Connect this terminal with T-319 priority and chime controls are activated from T-319(P.T.T remote) and Microphone cable with shield
can be extended at the max 30m.
IMPORTAN NOTICE:
Be sure not to make a shorten to the ground because microphone , -is for operating power of condensor
microphone.
15. CHIME INPUT
This is a terminal for chime signal.
