Page 3
SAFETY RULES
Follow all electrical and safety codes as well as the National Electrical Code (NEC), National Fire Protection Association (NFPA), and the
Occupational Safety and Health Act (OSHA). Qualified personnel should perform all electrical connections and wiring only.
National Fire Protection Association (NFPA) standards require specific duct design and dust collector configuration when collecting
potentially reactive metal dusts, such as aluminum, magnesium, and other materials. NFPA also covers other dusts such as grain and
plastics, etc. A guideline for determining the precautions to be taken can be found in NFPA 497. Other NFPA standards may apply to your
specific application. Consult current NFPA standards, available for NFPA, 1 Batterymarch Park, Quincy, MA, 02269, 800-344-3555, for
applicable safeguards which may be required for the Installation, Operation, and Service of this product.
Additional references are the Uniform Building Code and the Uniform Mechanical Code.
DISCLAIMER
Although instructions and recommendations are included for installation or your mist or dust collector equipment, the manufacturer does not
assume responsibility for the installation of this equipment nor shall be held liable for direct or consequential damages resulting from improper
methods, structural failure or inadequate supports.
WARNING
1.
Avoid mixing combustible materials such as (but not limited to) buffing lint, paper / wood dust, aluminum or
magnesium with dust generated from the grinding of ferrous materials. This creates a potential for fire due
to the mixing of sparks and combustible materials.
2.
Under no conditions should the machine operator be allowed to put lit cigarettes or any burning object into
this or any dust/mist control system.
3.
Installation of this unit in applications where there is a chance for heated and/or flammable materials to
enter the unit should be evaluated to determine if a fire protection/extinguishing system should be installed.
Federal, state or local codes, a required by organizations such as NFPA and Factory Mutual Insurance or
your insurance carrier may require such a system.
B
SE
can offer basic guidelines for such an installation;
however
4.
Explosion relief vents are required on some applications. Consult with an insurance underwriter or an
NFPA manual to determine proper vent size ratio. Dust or mist collectors must be located outdoors unless
otherwise indicated by NFPA standards. Dust and mist collectors DO NOT CONTAIN EXPLOSION
RELIEF VENTS as shipped from the factory and must be field installed per NFPA standards.
Always use BSE replacement filters - for reordering, please contact
your dealer or BSE.
WARRANTY INFORMATION
BSE warrants all products sold, only to purchasers for use in business or for resale, against defects in workmanship or materials
under normal use for one year after date of purchase from BSE. This warranty does include standard warranties from purchased
parts such as blowers, motors, valves, etc. All purchased items will fall under the manufacturers' standard warranty. Any part
which is determined to be defective in material or workmanship and returned to BSE or authorized service facility, as BSE
designates, shipping cost prepaid, will be, as the exclusive remedy, repaired or replaced, at BSE's option. Any liability for
consequential and incidental damage is expressly disclaimed. BSE liability, in all events, is limited to and shall not exceed, the
purchase price paid.
Title and risk of loss pass to buyer on delivery to the common carrier. If product is damaged in transit, recipient must file claim with
carrier. BSE will make a good faith effort for prompt correction or other adjustments with respect to any product that proves to be
defective within the warranty period.
