Bryant 559F, Installation, Start-Up And Service Instructions Manual

Page: 32 / 32

START-UP CHECKLIST
MODEL NO.:
DATE:
SERIAL NO.:
TECHNICIAN:
I. PRE-START-UP:
M
VERIFY THAT ALL PACKING MATERIALS HAVE BEEN REMOVED FROM UNIT
M
VERIFY INSTALLATION OF INDOOR FAN MOTOR ADJUSTMENT BOLT (180 UNITS) OR ADJUSTMENT
BOLT AND PLATE (216-300 UNITS)
M
OPEN ALL SERVICE VALVES (SUCTION, DISCHARGE, AND LIQUID)
M
VERIFY INSTALLATION OF ECONOMIZER HOOD
M
VERIFY THAT CONDENSATE CONNECTION IS INSTALLED PER INSTRUCTIONS
M
VERIFY THAT ALL ELECTRICAL CONNECTIONS AND TERMINALS ARE TIGHT
M
CHECK THAT INDOOR-AIR FILTER IS CLEAN AND IN PLACE
M
VERIFY THAT UNIT IS LEVEL
M
CHECK FAN WHEEL AND PROPELLER FOR LOCATION IN HOUSING/ORIFICE, AND VERIFY SET SCREW
IS TIGHT
M
VERIFY THAT FAN SHEAVES ARE ALIGNED AND BELTS ARE PROPERLY TENSIONED
M
VERIFY THAT SCROLL COMPRESSOR IS ROTATING IN THE CORRECT DIRECTION
II. START-UP:
ELECTRICAL
SUPPLY VOLTAGE L1-L2 L2-L3 L3-L1
COMPRESSOR AMPS — COMPRESSOR NO. 1 L1 L2 L3
— COMPRESSOR NO. 2 L1 L2 L3
SUPPLY FAN AMPS EXHAUST FAN AMPS
ELECTRIC HEAT AMPS (IF SO EQUIPPED) L1 L2 L3
TEMPERATURES
OUTDOOR-AIR TEMPERATURE F DB (Dry-Bulb)
RETURN-AIR TEMPERATURE F DB F WB (Wet-Bulb)
COOLING SUPPLY AIR F
ELECTRIC HEAT SUPPLY AIR (IF SO EQUIPPED) F
PRESSURES
REFRIGERANT SUCTION CIRCUIT NO. 1 PSIG CIRCUIT NO. 2 (216-300 ONLY) PSIG
REFRIGERANT DISCHARGE CIRCUIT NO. 1 PSIG CIRCUIT NO. 2 (216-300 ONLY) PSIG
M
VERIFY REFRIGERANT CHARGE USING CHARGING CHART ON PAGE 24
GENERAL
M
ECONOMIZER MINIMUM VENT AND CHANGEOVER SETTINGS TO JOB REQUIREMENTS
M
VERIFY INSTALLATION OF ALL OPTIONS AND ACCESSORIES
----------------------------------------------------------------------------------------
CUT
ALONG
DOTTED
LINE
CUT
ALONG
DOTTED
LINE
Copyright 1998 Bryant Heating & Cooling Systems CATALOG NO. 5355-900 CL-1