8.
Then, drill a hole with the Ø 3.2mm drill bit into the fixed profile of the pivoting
side (4) and the fixed profile (17), both at top and bottom. Use the rubber
washers and ST4x10 screws (13) to fix them in place. Press the screw caps
over the screws as shown in figure 7 and 8.
Ø 3.2
13
Figure
7 Figure
8
9.
Attach the horizontal anti-water strip (16) to the bottom of the pivot door (11).
Press the horizontal decorative strip (2) into the rail profile (1), both at top and
bottom as shown in figure 9.
10.
Attach the vertical anti-water strips (3) to both sides of the door (11) as shown
in figure 10.
3
16
2
Figure
9
Figure
10
11.
Finally, at all points connected to the wall, shower tray/ floor and the profiles,
use silicone sealant only on the outside of the cubicle.
18