Bandit
PRINTED 4/02
PAGE 18
MODELS 65A & 65AW
SAFETY DECALS
SAFETY DECALS
Safety Decals located on your Bandit Chipper contain useful information to assist you in operating your
equipment safely. Some of the decals on your machine and their location are shown in this section.
It is very important that all decals remain in place and in good condition on your machine. Please follow the
care and instructions given below:
1) You should use soap and water to keep your decals clean. Never use mineral spirits or
any other abrasive cleaners.
2) Replace immediately any missing or damaged decals. The location the decal is going
to be applied to must be clean and dry, and at least 40° F (5°C) before applying decal.
3) When the need arises to replace a machine component with a decal attached, be sure
and replace the decal.
4) Replacement decals are available, and can be purchased from the manufacturer or
your Bandit Dealer.
5) Spanish, Portuguese and other foreign language decals are available.
EXAMPLES:
NOTICE
DECAL MAINTENANCE IS THE
RESPONSIBILITY OF THE OWNER OF THIS
MACHINE. KEEP DECALS LEGIBLE. DECALS
(ETC.) ARE AVAILABLE IN OTHER LANGUAGES.
CONTACT: PARTS DEPARTMENT
6750 MILLBROOK RD.
REMUS, MI 49340
PHONE (888) 748-6348
DO NOT insert fingers or
amputation could occur.
DO NOT perform any
maintenance until belts inside this
hole have completely stopped
moving.
DANGER
DO NOT sit, stand, lay, climb or
ride anywhere on this machine
while it is running, operating or in
transit.
YOU WILL BE INJURED!
DANGER
THE CLUTCH HANDLE SHOULD NOT
BE ENGAGED OR DISENGAGED AT
SPEEDS ABOVE 1000 RPM’S.
DO NOT operate this Clutch/PTO unless proper adjustments and lubri-
cation are maintained per the Clutch/PTO Manufacturer’s Manual.
Different brands and models require different service and operation
procedures. New Clutch/PTO’s require more
frequent adjustment.
GOOD OPERATORS
DON’T WASTE MONEY!
Clutches will fail, glaze over, and burn up from
improper adjustment. This will cost the owner of this
machine thousands of dollars to repair. A well main-
tained, correctly adjusted clutch should function properly
for years.
NOTICE
Summary of Contents for 65A
