26
Operating Instructions (1.14)
© 2017 Brunner GmbH
WARRNING
In emergency operation always keep the damper flap wide open.
Lighting fire in a cold fireplace
Make sure that the level of ashes is not too high. Maximum level: 5 cm
below the door frame. When the ash bed becomes too high, the volume
of the combustion chamber is reduced and the flame formation needed
for a clean combustion process is disturbed.
Bring the combustion air valve in the starting up position.
The combustion air can flow strongly on the wood in order to heat up fast.
Load some chopped firewood loosely into the fireplace. Load the desired
amount of wood logs on this small wood. Put a good fire-starter, such as
Fidibus between the logs and light the fire.
Fire-starters are practical fire starting aids. Please note: big logs are not
easy to light and heavy to burn in a cold fireplace.
Never use petrol or alcohol as aids for lighting fire!
Close the firing door again and observe the heating insert for a while.
If the fire should expire, open the firing door slowly and put a new fire-
starter in between the woodlogs and light it on.
If no more fuel is needed, at the end of the combustion, this means when
