BRP Sea-Doo MOVE, Operator'S Manual

Page: 20 / 59

TRAILER SET-UP
219001876-008_a
TYPICAL
2. Load the watercraft on the trailer
and make sure that the bunks
rest flat on a flat part of the hull as
shown. If the bunks do not rest on
a suitable part of the hull, refer to
BUNK LATERAL POSITION
section.
smo2012-006-009_b
TYPICAL
1. Bunk resting flat
3. Tighten the bolts to specified
torque.
TIGHTENING TORQUE
Bunk retaining
bolts
7 N•m (62 lbf• in )
Bunk Lateral Position
WARNING
Always set both bunks to the same
lateral stance.
To adjust the position:
1. With the PWC off the trailer, loosen
the nuts on top of the support.
NOTE: The supports may have a block
underneath. The procedure is the
same.
219001876-007_a
TYPICAL
2. Slide the bunk to the desired posi-
tion.
219001876-010_a
TYPICAL
3. Tighten nuts to specified torque.
4. Adjust the angle if necessary, refer
to
BUNK ANGLE
.
TIGHTENING TORQUE
Bunk support nuts 41 N•m (30 lbf•ft)
Spark™ MOVE II Models
This trailer is specifically made to trans-
port the Spark PWC. No adjustment is
required.
NOTICE
Do not use this trailer to
transport any other model of PWC.
Use this trailer only to transport the
Spark models.
18
______________