BRP SEA-DOO ADVANCED TEC 2010, User Manual

Page: 30 / 63

LOADING THE WATERCRAFT
12. On both sides, secure rear of
PWC to the trailer using suitable
tie-downs attached to the stern
eyelets and trailer eyelets to-
gether.
smo2010-004-010_a
RH REAR OF TRAILER
1. Trailer eyelet
smo2010-005-001_a
1. PWC stern eyelet
2. Tie-down
3. Trailer eyelet
WARNING
Before towing, make sure:
– PWC is securely latched at front.
– iCatch mechanism is locked.
– PWC is secured to the trailer at
rear using tie-downs.
– PWC is secured to the trailer at
front using the safety cable.
13. Install taillights on trailer.
14. Connect taillights connector.
Loading the Watercraft
(ADVANCED TEC)
NOTICE
Taillights are not sub-
mersible, before launching or load-
ing, always remove taillights.
1. Disconnect taillights connector.
2. Remove taillights from trailer, refer
to
LAUNCHING THE WATERCRAFT
in this subsection for the procedure.
3. Have someone guiding you and
back the vehicle until the trailer
reaches the desired depth into wa-
ter.
NOTE: Bunks should be immersed in
water just enough for the watercraft to
be dragged onto them without floating
over them.
4. Align the watercraft with the trailer
bunks.
5. Unwind the winch and attach the
hook or strap to the watercraft's
front bow eyelet.
6. Set winch mechanism to "wind",
then wind until watercraft bow
reaches the trailer bow stop roller.
smo2010-003-011_a
SET WINCH TO "WIND"
7. Drive the tow vehicle out of the
ramp.
8. Secure personal watercraft (PWC)
on the trailer using suitable tie-
downs attached to the stern eye-
lets and trailer eyelets together.
28
______________
https://www.boat-manuals.com/