BRP SEA-DOO ADVANCED TEC 2010, User Manual

Page: 19 / 63

TRAILER SET-UP
TONGUE MEASUREMENT GUIDELINE
MODEL NAME MODEL YEAR
TONGUE
DISTANCE
RXT™, RXT™-X™ with S 3 hull™, GTX †
Limited, Wake Pro 215
2010
RXT™ iS, GTX
†
iS™, GTX
†
Limited iS™
2009-2010
40.6 cm
RXT™, GTX † , GTX † Wake™, RXT™-X™
(except S 3 hull™)
2002 through 2009 33 cm
GTI™, GTI™ SE, Wake 155 2006 through 2010 28 cm
RXP™ 2004 through 2010
RXP™-X™ 2008 through 2010
30.5 cm
To adjust, loosen the iCatch support
bolts, move support to the desired po-
sition, then tighten nuts as follows:
1. Progressively tighten nuts in a
crisscross pattern until support is
square with the trailer tongue.
2. Tighten to 8 N•m ± 1 N•m.
Fitting the Trailer to the
Watercraft (ADVANCED
TEC)
Set tongue weight, bow stopper roller,
and bunks as follows.
Tongue Weight
Move winch support towards front or
rear of trailer in order to adjust tongue
weight.
The tongue weight should be from 3
to 10% of the total trailer and PWC
weight with tongue parallel to the
ground.
To adjust, loosen the 4 nuts under-
neath the winch support u-bolts, move
winch support to the desired position,
then tighten nuts to 27 N•m ± 3 N•m.
smo2010-003-025_a
1. Winch support u-bolts nuts
Bow Stopper Roller
Set bow roller stopper so that it leans
on the PWC bow between rubber
bumper and bow eyelet.
To adjust:
1. Loosen the 2 nuts underneath the
front winch support u-bolt.
2. Remove the winch arm adjustment
bolt.
3. Set the bow roller stopper to the de-
sired height, then lock it in position
by inserting the bolt through the
aligned winch support and winch
arm holes.
_______________
17
https://www.boat-manuals.com/