BRP Can-Am RYKER 2019 Series, Operator'S Manual, Page: 115 / 179

MAINTENANCE PROCEDURES
A
B
219001998-093
TYPICAL - HEADLIGHT REFLECTION ON
TEST SURFACE
A. Line A
B. Line B
All Other Countries
1. Verify tires are correctly inflated.
See the
TIRE LABEL
located inside
the right side service cover.
2. Position the vehicle at 10 m (33 ft)
from a test surface.
Make sure the vehicle is level and po-
sitioned perpendicularly with the test
surface.
90°
A
219001998-095
TYPICAL
A. 10 m (33 ft)
90°
219001998-096
TYPICAL
3. Trace 4 lines parallel with the ground
on the test surface as per the follow
table:
LINES ON THE TEST SURFACE
(ABOVE THE GROUND)
Line A 486 mm (19.134 in)
Line B 449 mm (17.677 in)
Line C
517 mm (20.354 in)
Ryker
600
Line D 466 mm (18.346 in)
Line A 481 mm (18.937 in)
Line B 443 mm (17.441 in)
Line C 511 mm (20.118 in)
Ryker
900
Line D 461 mm (18.15 in)
Line A 466 mm (18.346 in)
Line B 429 mm (16.89 in)
Line C 497 mm (19.567 in)
Ryker
900
Rally
edition
Line D 446 mm (17.559 in)
4. Select HIGH beam.
5. Beam aiming is correct when the
focus point (brightest spot) of the
headlight reflection is between the
lines A and B.
A
B
219001998-093
TYPICAL - HEADLIGHT REFLECTION ON
TEST SURFACE
Line A
Line B
6. Select LOW beam.
7. Beam aiming is correct when the
focus point (brightest spot) of the
headlight reflection is between the
lines C and D.
______________
113