BRP 2013 Spyder RT, Operator'S Manual

Page: 135 / 191

MAINTENANCE PROCEDURES
4. Pull down the service cover using
the recess to release upper tabs
from the front fascia.
rmr2010-038-061_a
5. Pull out the rear tab.
6. Lift service cover to remove it.
NOTICE
Pay attention not to dam-
age the FCS switch.
7. Check the coolant level on the right
hand side. Coolant must be visible
without exceeding the COLD. level
mark.
NOTE: If engine is hot, coolant must
be visible without exceeding the HOT.
level mark.
rmo2013-005-001_a
1. Coolant reservoir cap
8. If required, add coolant until it is
visible in the reservoir. This will cor-
respond to a level between COLD
and HOT marks. Do not exceed the
HOT level mark. Use a funnel to
avoid spillage.
Do not overfill.
9. Reinstall the service cover.
NOTE: A coolant system that fre-
quently requires coolant indicates
leaks or engine problems. See an au-
thorized Can-Am roadster dealer.
Clutch Fluid (SM5 Model)
Clutch Fluid Level Verification
Check the clutch fluid level when the
clutch does not operate normally or
when it is difficult to shift gears with
the gearshift lever.
The clutch fluid reservoir is near the re-
verse button on the left handlebar.
Check the clutch fluid level as follows:
1. Park the vehicle on a firm, level sur-
face.
2. Set the handlebar straight in order to
position the top of clutch fluid reser-
voir horizontally.
3. Wipe clean the cap area.
4. Use the Phillips head screwdriver lo-
cated in the toolkit.
5. Unscrew cap retaining screws.
rmo2010-001-005
6. Carefully remove cap. Pay attention
not to drop the cap seal.
7. Look inside the reservoir to see the
fluid level.
______________
133