BROWN 410 Series, Operator'S Manual

Page: 39 / 44

Replacement Parts
39
2-Disc Slip Clutch (415, 416)
Ref. No. Part No. Description
1 255-0400 Bolt, Clutch Tension M10 x 50 (6 Req.)
1a 255-0660 Lock Nut, Clutch Tension M10 (6 Req.)
2 236-2214 Yoke, flanged, 2 disc
3 236-1703 Lining, clutch, 2 req.
4 236-2212 Hub, 2 disc, 1-3/4” z 20
5 255-0420 Bolt, Hub Clamp M12 x 65 (2 Req.)
5a 255-0680 Lock Nut, Hub Clamp M12 (2 Req.)
6 236-1705 Plate, thrust, 2 disc
7 236-1706 Spring, belleville, 2 disc
8 236-2210 Clutch assembly, 2 disc
1
1
2
3
4
5
3
6
7
8
4.0mm - 4.5mm
CLUTCH ADJUSTMENT PROCEDURE
415 - 416 2-DISC SLIP CLUTCH
To adjust the clutch to proper torque, the gap between the belleville spring and
the drive plate should be between 4.0-mm and 4.5mm. Tightening the nut one
revolution will compress the spring 1.5-mm. Tightening the nut one flat side will
compress the spring 0.25mm.
This can also be set by tightening each of the lock nuts until the spring is flat
against the drive plate and then loosening each nut 3 full revolutions. The clutch
may be adjusted by using two (2) 17-mm wrenches.