Browlee-Morrow Vulcan Pumps HDS 100L, Installation, Operation And Maintenance Manual

Page: 22 / 51

Document No. – A1540 Date – 23 January 2014 Revision – 0
Uncontrolled Copy
19
5.2 Preventative Maintenance
The pump operating condition should be monitored on an ongoing basis. It is recommended
that amperage draw, discharge pressure and flow rate readings be recorded frequently to
identify any changes in the pump performance that could indicate possible problems with the
pump or motor.
If the pump amperage, discharge pressure and flow rate have a significant change then it is
recommended to remove the pump from service and complete a mechanical and electrical
inspection.
The motors seal leak detection moisture sensor system protects the motor from damage to the
motor components. If the Inboard Mechanical Seal fails, the moisture sensor system detects
the failure and shuts down the pump.
The motor thermostats protect the motor from damage to the motor components due to
overheating. If the thermostats detect a high temperature the pump will shut down.
5.3 Maintenance Tools and Equipment
HDS 50L / 75L / 100L - A 150L / 75M / 100M - A 200L / 150M / 200M - A
Allen Wrench 3/8” 1/2" 5/8”
Allen Wrench 3mm 3mm 5mm
Allen Wrench 4mm 4mm 8mm
Allen Wrench 10mm 14mm 14mm
Torque Wrench 1.7 – 221 lb-ft (2.3 kN – 300 Nm)
Box Wrench 1” (24mm) 2” (50mm)
Box Wrench 13/16” (20mm) 1-7/16 (36mm)
Anti Seize Nickel Based
Loctite ® 262 High Strength
Grease Teflon Grease