© 2020 BROWAN COMMUNICATIONS INC.
16
Step 1: Positioning the wall mounting holes
Mark and drill suitable spots on the wall based on the measurements taken from the mounting
kit. The width between the two mounting holes ought to be 114mm apart and 38.1mm deep by
using a
Φ12.7mm
drill bit. As shown in the following figure below.
Figure 11 Width between the wall mounting holes
Step 2
:
Inserting stainless steel anchors
After drilling holes in the wall, insert and drive stainless steel anchors into the holes with a
hammer until they are fully fixed inside the wall.
Figure 12 Installation Diagram of Wall Mount Anchors (Stainless Steel)
