7
o
Remove the glue pen holder from the carriage, and then
remove the glue pen. Attach the pressing tool to the tip of
the glue pen holder, and then insert the holder into the
carriage.
p
Touch the "Start" key to apply the foil.
q
Feed out the mat, and then peel off the protective sheet
and then carefully peel off the material from the mat.
• While peeling off the foil transfer sheet, check that the foil
adheres.
• If the foil does not fully adhere, instead of fully peeling off the
foil transfer sheet, return it to its previous position, cover it
again with the protective sheet, and then rub over the top of
the sheet with a hard object.
r
Place the material on a level surface, and then slowly peel
off the foil transfer sheet horizontally to the material.
s
Repeatedly dab the top of the foil with the dust removal
sheet to remove any excess foil.
• Do not rub the foil with the dust removal sheet, otherwise the
foil may become damaged.
• For storage, attach the dust removal sheet to its storage sheet in
order to prevent it from being lost.
●
If too much or too little glue was applied, touch
in the
Gluing screen, and change the setting for “Glue Amount
Adjustment”.
●
If the line is too thick, decrease the setting for “Glue Amount
Adjustment”. If the line is too faint, increase the setting.
●
If the glue tracks are conspicuous or the glue lines are too
thick, reduce the setting for “Glue Pressure”.
●
If the foil does not adhere at all, the foil transfer sheet may
have been positioned upside down.
●
If the foil does not adhere, touch
in the Foil application
screen, and then adjust the setting for “Foil Pressure”.
Troubleshooting