5
e
Touch
to scan the material. Position the pattern so
it does not extend from the material and the foil.
• Make sure that the pattern is smaller than the foil (3.9" × 7.8"
(100 mm × 200 mm)).
f
Touch
on the object editing screen to set the
pattern fill settings and the gluing pattern. If you won't fill
a pattern, proceed to
• We recommend fill pattern “001”.
• We recommend the default settings for the fill line spacing.
• When applying glue only to lines, adjust the setting for
“Additional Line” to increase the thickness of the glue lines.
We recommend the default settings for the additional line
pitch. For details on specifying the settings, refer to “Using
Drawing Functions to Fill Patterns/Make Outlines Thicker” in
the Operation Manual included with your machine.
g
Select "Foil 1 (Glue)" on the preview screen.
h
Check the amount of glue remaining in the glue pen. Set
the scale on the "Glue Pen Scale" confirmation screen to
match the remaining amount of glue.
• Before using the glue pen, make sure that the resin ball is
removed from the tip of the glue pen.
i
Touch
, set the glue pressure to "0", and then touch
the "OK" key.
j
Press the metal tab on the glue pen holder, and then
insert the glue pen with its cap removed. Release the tab
after the glue pen snaps into place so that the pen is
secured. If you do not hear a click sound, the pen is not in
the holder properly. Gently lift the pen up and down in
the holder to ensure it is secure.
• Before inserting the glue pen, make sure that the pressing tool
is not attached to the glue pen holder.
• Be careful not to lose the removed pressing tool.
• Perform trial drawing by hand to check that the glue pen
dispenses the appropriate amount of glue. If the glue at the tip
has dried, it will dissolve during trial drawing.
• Immediately begin applying glue.
1
2
3
4