IV- 3
4.4 ERROR
MESSAGE
A list of the error messages that are indicated on the printer monitor is shown below:
Error Messages
Advices
No Errors.
None.
A roll of labels or tape is
not installed.
Install into the P-touch the roll of labels or tape indicated on the
monitor.
End of tape.
Set a new roll into the P-touch and then click on the
monitor.
Buffer full error in P-touch. Turn the P-touch off and then on. Click on the monitor.
P-touch tape cutter is not
operating.
(1) Before removing any jammed labels, turn off the P-touch.
(2) After removing jammed labels, retry the print. Be careful
not to injure your hands, etc. with the tape cutter.
Cannot change the roll of
labels or tape while
printing.
Turn the P-touch off and then on. Click on the monitor.
The roll of labels or tape
inside the machine does
not matches the one
selected in the
application.
Click [Details...] for further
assistance.
Install the correct roll of labels or tape into the machine and
then click on the monitor.
Click to cancel the print job. Go to the Page
Properties in the P-touch Editor and change the selection of
the supply roll so that it matches the one inside the machine.
Try printing the label again.
P-touch may have invalid
data in memory.
Turn the P-touch off and then on.
Cover open.
Close the cover.
Connected P-touch is not
QL-570.
Change the model to the correct one.
Tape cannot be fed.
(There may be no more
tape.)
Press [Details...] for further
assistance.
First check that the tape is not empty.
<If the taper is empty>
Install a new roll of labels or tape into the P-touch, and then
click on the monitor.
<If the tape is not empty>
Check the tape to ensure it is loaded correctly. Make sure
that the label path is not blocked. Then click on the
monitor.
Communication error
between PC and P-touch.
(1) Check that the P-touch is connected to your computer with
the USB interface cable (that comes with the P-touch).
Also check the cable for weak connection.
(2) Make sure that the P-touch is turned on. If any
communications error has occurred, turn the P-touch off
and then on.
Summary of Contents for QL 570 - P-Touch B/W Direct Thermal Printer
