LK3-B438E Mark II
8
!0
!1
!2
w
e
q
o
i
u
y
t
r
t
u
i
o
y
Table
Cushions
Cushion collars
Nuts
Flat washers
Rubber collers
3 m m
!3
3-4 . Installing the control box
1. Remove the 12 screws
q
, and then open the covers (panel mounting assembly
w
and main P.C. board
mounting plate
e
).
NOTE:
When opening the cover, hold it securely so that it does not fall down.
2. Install the control box with the four accessory bolts
r
, cushions
t
, cushion collars
y
, rubber collars
u
,
flat washers
i
and nuts
o
as shown in the illustration above. At this time, leave a gap of approximately
3 mm between the work table and the top of the box.
* Use two nuts
o
at each installation location, and make sure that both nuts are tightened.
3. Close the covers (panel mounting assembly
w
and main P.C. board mounting plate
e
), and tighten them
with the screws
q
.
* The main P.C. board mounting plate
e
will be opened again during “3-13. Connecting the cords”, so
provisionally tighten it with the screw
q
.
4. Install the power switch
!0
with the two screws
!1
.
5. Secure the power switch cord with the three staples
!2
.
6. Pass the motor cord through the cord hole
!3
.
3. INSTALLATION