LK3-B438E Mark II
7
q
w
e
r
y
u
q
e
Table
1 m m
t
q
w
e
3-2 . Installing the motor
Install the motor
u
to the work table with the four ac-
cessory bolts
q
, cushions
w
, cushion collars
e
, flat
washers
r
, spring washers
t
and nuts
y
.
At that time, fix by setting bolts
q
a little to the right
of oval hole on motor.
NOTE:
Tighten the nuts
y
so that the clearance between the table
and the cushion collars
e
is approximately 1 mm.
3-3 . Installing the motor pulley
Place the motor pulley
q
onto the shaft of the motor
w
so that the key groove is aligned, and then tighten
the set screw
e
so that the center of the V groove in
the motor pulley
q
is aligned as closely as possible
with the center of the belt hole in the power table.
3. INSTALLATION
