Brother Innov-is QC1000, Operation Manual

Page: 94 / 162

SEWING THE STITCHES
U
tili
ty
S
tit
ch
es
93
3
c
Position the fabric so that the opening of the
pocket moves toward you during sewing.
Hold the outside frame of the buttonhole foot
toward the back with your finger, check the
first needle drop point, and then lower the
presser foot.
a
First needle drop point: 2 mm (approx. 1/16 inch)
d
Pull down the buttonhole lever.
* The buttonhole lever should be positioned behind
the metal bracket on the buttonhole foot, as shown
in the illustration.
a Buttonhole lever
a Metal bracket
e
Gently hold the end of the upper thread, and
then start sewing.
* Once sewing is completed, the machine
automatically sews reinforcement stitches, then
stops.
* If the automatic thread cutting setting is selected
before sewing, the machine will automatically cut
the thread at the end of stitching.
■
Bar Tacks on Thick Fabrics
Place a piece of folded fabric or cardboard beside
the fabric being sewn to level the buttonhole foot
and allow for easier feeding.
a
Presser foot
b
Thick fabric
Note
• Slide the outside frame of the buttonhole foot
backward as far as possible, making sure that there
is no gap behind the part of the foot marked “A”, as
shown in the illustration. If the buttonhole foot is not
slid back as far as possible, the bar tack will not be
sewn at the correct size.
• Pass the thread under the presser foot.
a
a
a
Note
If the fabric does not feed, for example, because it is
too thick, press in the length display to increase
the stitch length.
a
b