IV-7
2.
OUTSIDE FRAME UNIT
2.1
Composition
Figure 4.13
2.2.1
Removing the outside frame unit from the Duplex unit
(1)
Turn and close the inside frame unit.
(2)
Disconnect the relay harness assy from the Duplex I/F PCB assy and the edge
saddle.
(3)
Pull out the fulcrum shaft R by using pliers.
(4)
Remove the fulcrum spring.
Figure 4.14
Paper pressure motor
Carriage guide 3
Outside frame L assy
Outside frame R assy
Tower bars
Inside frame unit
Fulcrum shaft L
Bearing collar
Fulcrum shaft R
Fulcrum spring
Retaining ring E6
Retaining ring E4
Outside frame unit
Summary of Contents for DX-2000
