Brother AE2700, Service Manual

Page: 160 / 205

In
spection and Adjustment
In
spection and Adjustment
4 - 7
Adjustment Motor belt tension
„
220 to 240V specification
[Standard]
The belt slack should be 4.6 to 6 mm when pushing the center of the motor belt between
the T pulley of the upper shaft and the T pulley of the motor with a force of 0.98 N (100g).
[Adjustment]
1. Turn off the power, and then remove the foot controller.
2. Remove the face plate and the pattern selection dial, and remove the front cover and
the rear cover.
3. Loosen the 2 screws
1
of the motor holder.
4. Move the motor holder up and down to adjust the tension of the motor belt.
5. Tighten the 2 screws
1
of the motor holder to secure the motor holder to the arm bed.
<In case of 120V specification, refer to previous page.>
1
XC2277001 Push-pull gauge (5N)
BOLT.
(S/P WASHER)
M5X12
Motor belt
1
Motor holder
Push-pull gauge
4.6 - 6 mm
Motor belt tension
0.98 N (100g)