11
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Needle and embroidery foot
section
a
Thread guide disk (page 40)
Pass the thread through the thread guide disk when
using the needle threader to thread the needle.
b
Needle bar thread guide (page 40)
Pass the upper thread through the needle bar thread
guide.
c
Needle plate
When the needle is lowered, it enters the hole in the
needle plate.
d
Needle plate cover (page 78)
Remove the needle plate cover to clean the bobbin case
and race.
e
Bobbin cover/bobbin case (page 35)
Remove the bobbin cover, and then insert the bobbin
into the bobbin case.
f
Embroidery foot “Q” (page 80)
This presser foot is used for embroidering.
Right-side/rear view
a
Handle
Carry the machine by its handle when transporting the
machine.
b
Handwheel (page 38)
Turn the handwheel toward you (counterclockwise) to
raise and lower the needle.
c
Embroidery card slot (page 55)
Insert the embroidery card.
d
USB port (for a USB flash drive (USB flash memory))
In order to import patterns from a USB flash drive (USB
flash memory), plug the USB media directly into the
USB port.
e
Air vent
The air vent allows the air surrounding the motor to be
exchanged. Do not cover the air vent while the machine
is being used.
f
Main power switch (page 18)
Use the main power switch to turn the machine on and
off.
g
Power supply jack (page 18)
Insert the plug on the power supply cord into the power
supply jack.
Memo
z
Refer to pages 10 through 13 while you are
learning to use your machine.
