Broseley Canterbury PD-08-002, User Instructions

Page: 29 / 42

Page 25
3.9.10 Log Effect Layout
The LOG SET comprises of the following:
PART QUANTITY
Rear Ceramic 1
Front Ceramic 1
Straight Logs 2
Large ‘Y’ Log 1
Small ‘Y’ Log 1
Stubby ‘Y’ Log 1
Proceed with the layout as follows:
1. Position the rear burner ceramic behind
the rear burner flange, see Figure 27
2. Place the front burner ceramic in its
supports in front of the burner as in
Figure 28 . Lift the rear ceramic so that
the front ceramic slides in easily.
3. Place one
straight log
on the rear
ceramic, across the rear right hand side,
with the burnt end facing right. Place the
other
straight log on the left hand side,
with the burnt end facing front, bridging
between the front and rear ceramic (see
Figure 29)
4. Place the large ‘Y’ log across the front
ceramic with one of the legs of the ‘Y’
resting on the straight log at the back
(see
Figure 30 ).
5. Proceed with placing the small ‘Y’ log,
bridging between the front and rear
ceramic and behind the front ‘Y’ log, as
in
Figure 31
.
6. Finally place the
stubby ‘Y’ log
in the
left hand rear corner (see Figure 32 ).
7. It is recommended that the fuel effect be
left alone once the desired flame picture
has been achieved.
Constant moving
of the fuel effect causes the fuel effect
to
disintegrate and/or cause
discolouration.
Figure 27
Figure 28
Figure 29
Figure 30
Figure 31
Figure 32