Brose Allround, User Manual

Page: 34 / 40

Troubleshooting | Brose Display Allround EN | 34
6. Troubleshooting
ATTENTION
Always observe all error information!
IMPORTANT INFORMATION
Have repairs done by a certified bicycle dealer
only.
The
«Allround»
display/control unit displays
error messages from the entire pedelec
system.
The fault display indicates fault that the
system can detect independently.
Depending on the type of fault, the drive
may be automatically switched off. Check
the e-bike before making any further trips.
Driving on without the assistance of the drive
is possible at any time.
Depending on the type of fault, the drive
may be automatically switched off. Check
the e-bike before making any further trips.
Driving on without the assistance of the drive
is possible at any time.
›
The fault display may indicate serious
errors in your Brose Drive system. Errors
prevent the safe operation of the e-bike.
There is a risk of accidents involving
personal injury and damage to the e-bike.
›
Stop riding the e-bike. Inform yourself
about the meaning of the error information
and take note of the solution.
›
If the meaning of the information is
unclear, stop riding and turn the bike off.
Contact the bike manufacturer, dealer or
workshop on the next steps concerning
further progress.
Fault information Remedy
Speed sensor fault
Check the speed sensor and position of the spoke
magnet.
Bicycle lighting faults
Turn off the system completely. Then check all
cables and connectors of the front and/or rear
lighting system. Restart the system.
Internal system error identified Restart the system.
Brake lighting faults
Turn off the system completely. Then check all
cables and connectors of the brake system. Restart
the system.
Tab. 07: Fault Information
If you experience any problems using your
Brose Drive System, first check the items
listed in the following table. In many cases,
you can already remedy this yourself.