Brose Allround, User Manual

Page: 26 / 40

Assembly | Brose Display Allround EN | 26
4. Assembly
The control unit can be mounted on both the
left and the right side of the handlebar.
NOTE
Brose recommends positioning on the left side
of the handlebar.
Check all fixing screws regularly. Shocks, heat
and cold can cause the screws to become
loose. Tighten all screws to the required
torque.
›
Carefully remove the grip and open the
brake, gears and all other components
mounted on the selected handlebar side.
›
Carefully loosen the hexagon socket screw
with a size 2 wrench (Fig. C-g) on the
control unit.
» NOTE:
The screw cannot be removed
from the control unit.
›
Now slide the control unit from the side
onto the handlebar.
›
Position the control unit close to the grip,
so that all keys can be easily pressed with
the thumb.
›
Make sure that the connection cable is not
crushed or bent.
›
Now tighten the hexagon socket screw
slightly with a size 2 wrench. Do not
tighten the screws yet. Check the position
of the control unit.
»
Can all keys be reached with the thumb?
»
Is the display clearly visible?
›
Tighten the hexagon socket screw with the
wrench (Fig. C-g).
»
Torque 0.5 Nm
›
Connect the control unit cable to the motor
cable connectors (Fig. C-h). This may vary
depending on the features of your e-bike.
NOTE
Please make sure that the operation of safety-
relevant parts (e.g. brake grips) is always
ensured.
Please make sure that display is clearly visible.
5. Operation and Control
5.1. Before First Use
Commissioning of the display and control unit
requires no further steps after installation. The
display/control unit is ready for use as soon
as it has been correctly connected and the
battery is sufficiently charged.
NOTE
A full function is only possible if the speed
sensor and all cables have been connected
correctly and the battery is charged.
The display unit does not have its own battery
and therefore cannot be used or operated
outside the e-bike.