Brose Allround, User Manual

Page: 29 / 40

Brose Display Allround | Operation and Control 29 | EN
When the light is on, an icon appears in the
status bar (Fig.2-2) on the display.
Light status
Lighting not activated
Lighting switched on
Automatic control activated
Tab. 03: Light Status
Switching the bike lights on and off has no
influence on the display backlight.
NOTE
Is the battery removed or fully discharged, the
light does not turn on if it is connected to the
electric power system. Be aware that using the
bicycle under these conditions will be
considered non-observance of the road traffic
laws.
System information
Check
Speed
sensor
kmh
14
,
9
Fig. 3: Sample Error
The following is displayed to you in the status
bar:
Error & status symbols
Battery reserve is reached or
battery is drained and the system is
switched off
A fault has occurred (refer to
Troubleshooting chapter)
Tab. 04: Error & Status Symbole
Battery charge level
The battery charge level (Fig.1-3) is shown on
the display of the display unit with 5 segments.
Each segment corresponds to approx. 20% of
the battery capacity.
Depending on the features of your e-bike,
the battery charge level can also be from the
battery itself.
If the battery charge level is <10%, the
charge level indicator will start flashing. If the
charge state is <5%, the last segment of the
display turns red. In this condition, the motor
assistance is switched off to ensure the use
of lighting for an additional 2 hours in an
emergency.
If the battery is being charged on the wheel, a
message will be displayed.
75 %
Fig. 4: Battery Charging