Operation & Installation Manual RFS1 V2
MA365 Rev 3
35 of 46
DIP switch setting). If this is set incorrectly, the panel will indicate a fault and the
panel buzzer will sound in short intervals. Refer to Table 6, page 25 for correct DIP
switch setting.
7.3
Low Battery (RFS1 System)
If the battery in RFS1 becomes depleted, the panel buzzer will sound and defect
LED will illuminate. Check the mains supply to the panel and if missing restore as a
matter of urgency. If the mains is intact, change the battery.
7.4
Connection Fault
The connection from RFS1 V2 to all Alarms must be wired as shown in Figure 18,
page 38
If interconnect
IN
and interconnect
OUT
are reversed in any Alarm in the zone circuit,
a fault will be generated in RFS1.
