WARNING!
IMPORTANT INSTALLATION INSTRUCTIONS
IMPROPER INSTALLATION CAN LEAD TO SEVERE INJURY OR
DEATH
READ AND FOLLOW ALL INSTRUCTIONS
•
Install only on a properly operating and balanced swing door within the rated values for door weight, door width and operating
torque as stated on the ratings label.
•
Do not connect door operator to source of power until instructed to do so
•
This door operator shall be installed and serviced by a qualified technician, electrician or electrical maintenance person
familiar with its operation and the potential hazards involved.
•
Any person performing installation or service on this product shall read this manual first. Proper installation includes following
all steps outlined in the
Installation Instructions
and the settings specified under the
Parameters
section.
•
Assure the force settings are compliant with UL 325 (29.4 Entrapment) and the door speeds (closing/opening times) are set
per Table 1of this manual.
•
Assure all electrical wiring and grounding is installed as specified in this manual and as required by any local codes. Proper
installation can also reduce the risk of electrical shock, fire or explosion.
•
Locate activation switches or push button stations: (a) within sight of the door, (b) at a minimum height of 5’ so small children
cannot reach and (c) away from moving parts of the door.
•
As described in this manual, the Stop command controlled by the motor drive is not intended to be a fail safe or Emergency
Stop (E-Stop) since it does not prevent the motor drive from malfunctioning. This can only be accomplished by disconnecting
the AC power to the operator (terminals L1 and N).
•
This door operator is to be a permanent or “hard” wired connection to the supply voltage. The electrical contractor shall install
a dedicated breaker or line switch to disconnect each ungrounded pole of the door operator from the supply voltage. Each
ungrounded pole shall have a minimum of 3mm contact separation
•
If this model is equipped with a manual release, disengage pin(s) between door and door operator before manually moving
the door
Summary of Contents for NB-2000-HD2
Page 14: ......
