brondell Revive PR50-B, Owner'S Manual

Page: 31 / 104

29
CONDITION POSSIBLE CAUSE POSSIBLE SOLUTION
No air is blowing.
Plastic packaging on filters was not
removed. Remove the plastic packaging and
put the filters back in.
The power cord is not plugged in or
properly inserted into the electrical
outlet.
Plug the power cord into an electric
outlet rated for 120V.
Power plug or cord is damaged.
Contact the Brondell Service Center
at 888-542-3355.
The Revive is not powered on. Press the Power Button.
CONDITION POSSIBLE CAUSE POSSIBLE SOLUTION
Only the
Air Purification
(AIR) and
Humidifying (HUM)
indicators are
illuminated.
The Light Off Button has been
pressed.
Press the Light Off Button again
to restore the control panel to full
illumination.
CONDITION POSSIBLE CAUSE POSSIBLE SOLUTION
1. Fan speed does
not automatically
adjust when in
Auto Mode.
2. The color of the
Air Quality Indicator
never changes.
Manual Mode is selected. 1
Press the Mode Button until “Auto”
is illuminated.
Air Quality Sensor is dirty. 1, 2
Follow the steps on page 28 to
clean the Air Quality Sensor.
Air Quality Sensor sensitivity is
inadequate for the air quality in
the room.
1, 2
Follow the steps on page 19 to set a
different Seasonal Allergy Setting:
• If the Air Quality indicator is Blue,
use a higher sensitivity.
• If the Air Quality Indicator is
Purple or Red, use a lower
sensitivity.
Air Quality Sensor is broken or is
malfunctioning.
1, 2
Contact the Brondell Service Center
at 888-542-3355.
TROUBLESHOOTING