brondell 1018505, Owner'S Manual

Page: 26 / 92

24
MAINTENANCE (cont.)
CLEANING THE MESH FILTER
PRODUCT STORAGE & USE
Cleaning intervals will differ depending on use and water
quality. It is recommended to check the filter at least
once a year.
1. Turn off the water supply, unplug the Swash, and
remove the seat from the toilet using the Quick
Release button on the left side of the unit (see diagram
on page 9).
2. Remove the Mesh Filter by turning with a Phillips head
screwdriver.
3. Clean the filter with a toothbrush while running under
tap water to effectively remove any foreign substances
or build-up.
4. Replace the Mesh Filter and carefully check that it is
installed correctly.
If improperly installed, it could result in the product
leaking water.
Replace the seat and turn the water supply back on.
Step 2
Step 3
Short Term Non-Use
If the product will not be used for more than a few weeks, you can simply unplug it. You may
also consider shutting the water supply off at the wall for extra precaution.
Long Term Non-Use
If the product will not be used for an extended time
(longer than four months), you should unplug the unit,
shut the water supply off at the wall, and then drain the
hot water heater. To drain the hot water heater, remove
the drain plug and the back of the bidet seat by turning
it counterclockwise by 90 degrees (Image “1”) and then
pulling it forward (Image “2”) so that any residual water in
the tank drains out.