19
Note:
With Topas A8 Evolution the acoustic flash trigger control is only activated, if
per channel one of the two lamp base outlets are occupied.
11. Service/repair
Your broncolor power pack is a precision device which will work for many years without
malfunctions if you take proper care of it. If malfunctions do arise, please do not attempt
to open the unit to repair it yourself. Even when the unit is shut off, dangerous voltages
may remain within the interior of the device. Leave service and repairs to our broncolor
repair service.
12. Car battery converter
If no mains (AC-line) power is available, use the 12 V/220 V car battery converter
.
The modelling light cannot be used in this mode (excessive load on battery) and must
be removed.
- Switch off modelling light and disconnect the lamp base from the power pack.
- Connect converter to the 12-volt car battery with the + and – terminal clamps.
- Connect unit to converter; switch on converter and unit.
- After flash work, switch off converter during pauses. Charge battery if needed by
allowing the car engine to run.
- 1 Topas A can be connected to the converter.
13. Lamp bases
The following information applies to Pulso, Unilite, Primo and Picolite lamp bases.
13.1
Replacing flash tubes
Prior to any change of the flash tube, the lamp base must be disconnected from the
power pack!
