B102521-0-0219
Page 13
CONTROL
PANEL
CONTROL
PANEL
SHIELD
If Side Shelf Accessory was purchased
install at this time. Follow Side Shelf
Follow Side Shelf instructions.
Note: If Side Shelf Accessory was
purchased install at this time.
Attach the ground wire to the ground lug. Slide both
the ground wire and electrode wire through the hole in
the center of the Control Panel Shield. Ease the
Control Panel Shield over the studs on the Control
Panel. Then insert the two studs through the holes on
the front of the grill. Attach with the two keps nuts.
Remove plastic film from label.
Connect the ground wire to the ground lug and run both ground
and electrode wires through hole in Control Panel Shield.
GROUND LUG
KEPS NUT,
SS, 10-24
B073967(2)
3/8”
ATTACH IGNITOR WIRE, INSERT CONTROL PANEL
