LIGHTING
4
LIGHTING INSTRUCTIONS
•
The infrared side burner must be assembled and
installed as per the assembly and installation
instructions. See page 8.
•
Ensure the grill is properly connected to the LP or
Natural Gas supply.
•
Ensure there are no gas leaks in the gas supply
system. See: “Leak Testing.” (Page 3).
•
Ensure that ignition wire is connected.
•
Check that the battery has been installed in the
electronic ignition.
•
Carefully review all instructions on the information
plate attached to the gas grill.
1. Open lid before lighting.
2. Do not lean over gas grill while lighting.
3. Set control knobs to “OFF” and turn on the gas supply.
LIGHTING THE INFRARED SIDE BURNER:
To light burner with the Ignitor:
4.
Push and turn side burner control knob to “HIGH.”
5.
Push and hold the ignitor button.
6.
Burner should ignite within 5 seconds.
To light burner with a match
:
4.
Apply lit match to burner ports.
5. Push in the side burner control knob and turn to
“HIGH.”
6. Burner should ignite within 5 seconds.
Note: Pots on the side burner must not be less than 1” (2.5
cm) or exceed 9” (23 cm) in diameter or 15 lbs. (7 kg) in
weight.
IF BURNER DOES NOT IGNITE:
•
Push and turn control knob to “OFF.” Wait 5 minutes
then try again with control knob set at “MEDIUM.”
•
If burner will not light, see “Troubleshooting” on page 7.
If problem persists, do not attempt to operate the
appliance; contact OMC, your dealer or an approved
service center.
SHUTDOWN:
1. Turn off cylinder valve.
2. Turn control knobs to “OFF.”
A. IGNITOR
B. SIDE BURNER CONTROL
C. SIDE BURNER
Summary of Contents for 18672
