3
1. SPECIFICATIONS/GENERAL INFORMATION
Fire damper suitable for installation on a wall, light wall and ceiling made from duct and galvanized steel compo-
nents, calcium silicate blade mono slab sp. 25 mm with perimeter seals to ensure sealing requirements to cold and
hot smoke. The control device ( manual with electromagnetic release or motorized ) consists of a plate removable and
replaceable even after installation, on which they are installed all the elements necessary for the proper operation and
functioning of the fire damper; the particular geometry of the control mechanism, prevents that the pressure present
in the duct (up to 500 Pa) opening the blade if not acting directly from the reset lever. When installation is completed,
the command will be out of the masonry simplify any post-installation actions. The dampers, installed according to
the instructions in this manual , are used in HVAC systems by restoring the partitioning between two rooms, ensuring
perfect insulation from heat and smoke seal.
The installer has the obligation to follow the installation procedures
and use of the equipment described in this manual, in order to comply with the same conditions as the samples
to be tested. Any deviation from the instructions, affect the validity of the certification of the product and the
declaration of correct installation.
2. NORMATIVE REFERENCES
Fire dampers tested according EN 1366/2 and classified according to EN 13501/3.
Legend
E = integrity
I = thermal insulation
S = smoke seal
V
e
= vertical installation
h
o
= horizontal installation
i
o = side exposed to fire indifferent
MA = manual reset device
SE = device with servomotor
CLASSIFICATION OF RESISTANCE
SUPPORT
EI 120 S - 500 Pa
EI 90 S - 500 Pa
Aerated concrete wall thickness 100 mm
(V
e
i
o)
from 100x200 to 800x600
MA/SE
from 100x200 to 800x600
MA/SE
Aerated concrete slab thickness 150 mm
(h
e
i
o)
from 100x200 to 800x600
MA/SE
from 100x200 to 800x600
MA/SE
Gypsum plasterboards type F wall thickness 100 mm*
(V
e
i
o)
from 100x200 to 800x600
MA/SE
from 100x200 to 800x600
MA/SE
Gypsum plasterboards type F thickness 100 mm
(V
e
i
o)
-
from 100x200 to 800x600
MA/SE
* Need to use thermo expanding gasket model LFC