16
Converged Enhanced Ethernet Administrator’s Guide
53-1002163-02
CEE Command Line Interface
2
DRAFT: BROCADE CONFIDENTIAL
NOTE
At system startup, if you try to enter privileged EXEC mode before the system has fully booted, the
following message is displayed:
%Info: Please wait. System configuration is being loaded.
After the system has fully booted, a RASlog message indicates that the CEE CLI is ready to accept
configuration commands.
TABLE 4
CEE CLI command modes
Command
mode
Prompt
How to access the command mode
Description
EXEC
switch>
Enter the cmsh command at the
Fabric OS prompt after you have
logged in as an appropriate user.
Display running system information
and set terminal line parameters.
Privileged
EXEC
switch#
From the EXEC mode, enter the
enable command.
Display and change system
parameters. Note that this is the
administrative mode and also
includes EXEC mode commands.
Global
configuration
switch(config)#
From the EXEC mode, enter the
configure terminal EXEC command.
Configure features that affect the
entire switch.
Interface
configuration
Port-channel:
switch(conf-if-po-63)#
10-Gigabit Ethernet (CEE port):
switch(conf-if-te-0/1)#
VLAN:
switch(conf-if-vl-1)#
From the global configuration mode,
specify an interface by entering one
of the following commands:
•
interface port-channel
•
interface tengigabitethernet
•
interface vlan
Access and configure individual
interfaces.
Protocol
configuration
LLDP:
switch(conf-lldp)#
Spanning-tree:
switch(conf-mstp)#
switch(conf-rstp)#
switch(conf-stp)#
From the global configuration mode,
specify a protocol by entering one of
the following commands:
•
protocol lldp
•
protocol spanning-tree mstp
•
protocol spanning-tree rstp
•
protocol spanning-tree stp
Access and configure protocols.
