Broaster 2400 Series, Installation Manual

Page: 21 / 32

4 - 2400E INSTALLATION
4-1
GENERAL REQUIREMENTS
• When installing or servicing the unit,
always check the dataplates, located
toward the rear of the countertop. This
will make certain proper parts are used
and the correct service rendered. DO
NOT apply a voltage to this unit other
than that shown on the data plate. If in
doubt, consult your local power com-
pany.
• A remote circuit breaker or fuse should
be installed in main power supply
located in a path of exit and clearly iden-
tified.
ELECTRICAL CHARACTERISTICS
These models are available for either 208 or
240 applied voltage, 60Hz, 3 phase electri-
cal connection in the USA. 220 or 240
applied voltage, 50/60Hz, 3 phase connec-
tion in the European Union.
Be sure to check the wiring diagram located
inside the front panel. It shows electrical cir-
cuits and connections. See Access For
Hook-Up under ELECTRICAL HOOK-UP.
When installed, the unit must be electrically
grounded in accordance with local codes,
or in the absence of local codes, with the
National Electrical Code, ANSI/NFPA 70, or
the Canadian Electrical Code, CSA C22.2,
as applicable.
ELECTRICAL CONNECTIONS
• Use copper wire only for connections.
• If power run is over 50 feet, use next
larger size wire.
2400E Suggested Wiring Capacity Table:
Phase Volts Amps Wire
Breaker
or Fuse
3 240 40 #8 50
3 208 42 #8 60
3 220/380 29.5 #8 40
3 230/400 25.2 #8 35
3 240/415 26.3 #8 35
broaster.com Manual #17278 9/13 Rev 10/15