Broaster 1600, Installation Manual

Page: 52 / 56

5-2
GAS:
DO NOT operate unit with-
out filter pan and filter pan
cover in its proper position. Filter pan cover
must be wiped clean after each filtering
cycle.
1. Clean unit as outlined in the operation
manual.
2. Make sure all controls are OFF.
3. Install cover O-ring as outlined under
COVER in CLEANING section of oper-
ation manual.
4. Fill cooking well with cooking oil. See
PRE-COOKING PREPARATIONS in
operation manual.
5. Turn circuit breaker ON or install fuse.
6. Turn cook/filter switch to COOK. The
HEAT ON light will illuminate indicating
the cooking oil is being heated.
NOTE: Check to make sure burner is
actually lit. If not see LIGHTING
INSTRUCTIONS
7. Check flame on top of burner. It
should be all blue and settled on the
face of the burner. If it is not check to
make sure the air shutter is locked in
place.
NOTE: If it is loose see the AIR SHUT-
TER ADJUSTMENT procedure.
8. If CHEC appears in display, turn unit
off and back to COOK.
9. Set timer and temperature controls.
10. Turn pressure regulating valve handle
to CLOSED. The timer will start count-
ing down. At the end of a cook cycle,
an audible alarm will sound until pres-
sure regulating valve handle is turned
to OPEN.
1800GH LIGHTING INSTRUCTIONS
Start-Up:
1. Turn cook/filter switch OFF.
2. See OIL LEVEL in the operation man-
ual.
3. Turn gas shut-off valve (1) ON. Wait
five minutes before turning gas control
ON.
4. Slide switch (2) on top of gas control
to ON.
Note: The model 1800GH has an intermit-
tent pilot burner. This type of pilot lights
when the controller calls for heat and goes
out when the controller isn’t calling for heat.
5. To light pilot and main burners, turn
cook/filter switch to COOK.
broaster.com Manual #14678 1/99 Rev 2/14