page 10
HOW TO USE POWER BRUSH/WAND
WAND RELEASE
The power brush is not
recommended for use on
bare floors. Wand release
pedal (
A
) on power brush
allows you to quickly
disconnect wand and switch
to combination floor/rug tool
for use on bare floors.
POWER BRUSH NECK RELEASE
Push down power brush neck release pedal (
B
) to unlock
brush neck. Return the neck to the upright position for storage.
POWER BRUSH HEIGHT ADJUSTMENT
The icons (
D
) refer to the carpet pile
height. Select height by depressing
height adjustment pedal (
C
) to desired
position:
(Extra-Low), (Low),
(Medium) or (High).
H
EIGHT ADJUSTMENT LED INDICATORS
The LEDs show the carpet pile covered
by the selected height, e.g.: when
(High) is selected, all LEDs will be lit, since this height
covers all pile heights. So if (Extra-Low) is selected, only the
lowest LED will be lit.
WAND LENGTH ADJUSTMENT
Extend (
E
) or shorten (
F
)
the wand to comfortable
work position by holding
the wand grip (
G
) in one
hand and sliding the upper
section (the one with the
prongs) with the other
hand.
FLOOR
HEIGHT
B
C
D
F
E
A
G
CAUTION
Always pick up hard or sharp objects by hand
before using your power brush. Items such as pins,
hairpins, tacks, crayons, etc., may damage the
brush roll or may break the belt.
CAUTION
Always unlock brush neck before use.
AO0020
AD0022
AD0023
AD0024
EDGE CLEANER
Brush extends full width for effective edge cleaning along both
sides of nozzle. To operate, simply run cleaner along edge
board. Rubber bumper protects furniture and baseboards.
ELECTRONIC CIRCUIT BREAKER
The power brush is equipped
with an electronic circuit breaker
that protects the motor and the
belt if a too large object is
picked up accidentally.
If the power brush stops while
vacuuming, turn the power unit
off using handle. Release the
power brush from the wand
and turn it over to see if there is an obstruction. When brush
roll jam has been cleared, press the reset button (
H
) and
connect the power brush back to the wand. Finally, turn the
power unit/power brush back on. If it fails to restart or continues
to trip without any apparent reason, the power brush must be
serviced by an authorized service center.
CLEANING AND STORAGE
CLEANING BRUSH ROLL
In order to keep high cleaning efficiency and to prevent
damage to your vacuum cleaner, the brush roll must be
cleaned every time the belt is changed.
The brush roll must also be cleaned according to the following
schedule:
V
ACUUM CLEANER USE
C
LEAN BRUSH ROLL
Heavy (used daily)
Every week
Moderate (2-3 times per week)
Every month
Light (1 time per week)
Every 2 months
Check and remove hair, string and lint build-up frequently in
the brush roll and end cap areas. Remove any dirt or debris in
the belt path and in the brush roll areas.
CLEANING HOUSING
To keep the power brush housing clean, it can be wiped with
a damp cloth and a mild soap solution, then thoroughly dried.
Never use any type of chemical as they can damage the housing.
STORAGE
1.
Ensure that hose and power cord are disconnected from
wall inlet before unplugging power brush.
2.
Disconnect hose handle from wand.
3.
Always keep hose neatly coiled when not in use.
4.
When not in use, the power brush should be stored in a
clean, dry place.
WARNING
Disconnect electrical supply before servicing or
cleaning the unit. Failure to do so can result in
electrical shock or personal injury from cleaner
suddenly starting.
!
AD0030
H
