4
1. INSTALL DUCTWORK AND ELECTRICAL WIRING
Plan where and how the ductwork will be installed.
A straight, short duct run will allow the hood to perform most
efficiently.
Install proper-sized ductwork, elbows and roof or wall cap.
Connect metal ductwork to cap and work back towards the
hood location. Use 2” metal foil duct tape to seal duct joints.
Run 3-wire power supply cable to installation location.
For best capture of cooking impurities, the bottom of
the hood must be located at a minimum distance of 36”
above cooking surface.
18"
W
ALL
CAP
36"
MINIMUM
ABOVE
COOKING
SURFACE
16"
TO
TOP
OF
WOOD
MOUNTING
STRIP
O
PTIONAL
DECORATIVE
FLUE
OR
SOFFIT
HH0182A
R
OOF
CAP
10" R
OUND
DUCT
10" R
OUND
ELBOW
10" R
OUND
ADAPTER
CAUTION
This range hood is intended for outdoor covered patio or lanai area. As with all electric
appliances, this unit must be protected from the effects of weather.
WARNING
!
This range hood is not designed for use with a charcoal grill.
WARNING
!
The power cable must be a GFCI protected
branch circuit.
2. PREPARE
INSTALLATION
NOTE: Before proceeding to the installation, check the contents of the box. If items are missing or
damaged, contact the manufacturer.
Make sure that the following items are included:
- Range
hood
- Wood strip (attached to back of hood)
- Installation
manual
- Accessories
including:
• Baffle filter with handles: 3 for 36” width model, 4 for 42” and 48” width models
and 5 for 60” width model
• 10” round adapter (taped inside the hood)
• Bag of parts: 3 waterproof wire connectors, 2 no. 8 x 5/8’’ screws, 6 no. 10 x 2’’ hex head screws,
4 no. 10 x 2” flat head screws, 2 wall anchors, 2 washers 3/16’’ ID x 3/4’’ OD
Included in parts bag, but not to be used (please discard): 2 wire clamps LP16-AP,
2 no. 8 x 3/8’’ zinc-plated screws, 8 no. 8 x 3/8’’ stainless steel screws,
4 stainless steel 10-32 locknuts, 4 washers 3/16’’ ID x 3/4’’ OD
WARNING
!
When performing installation, servicing or cleaning the unit, it is recommended to
wear safety glasses and gloves.
