ATTACHING THE SIDES AND FRONT SHEET TO THE ROOM SYSTEM
Slide the plastic profiles into the end of the roof sheet cover.
There are 2 side rafter bars that splice together with a joiner. These connect to the awning to enable the side sheets to
attach.
Slide the open channel of the side rafter onto the cover with the double pin at the top which connects into the 2 drilled
holes at the end of the awning cassette. Once slid in the front threaded pin passes through the drilled hole in the lead rail
and secures with a female hand wheel. Tighten all hand wheels.
Please note the first time of use the rafter bars may need the length trimming once the angle is set as this length can vary
according to the pitch required. Tip. spray with silicone spray to ensure smooth sliding in of the panels.
Slide the panel into the rafter and unzip the vertical zips in the side sheets. Slide the back edge into the rail attached to the
vehicle. Slide the front sheets into the lead rail. Unzip the vertical zips and slide the roped keder edge into the legs from the
top down and refasten the zips.
