MegaRAID SAS 9361-24i RAID Controller Quick Installation Guide
February 20, 2017
Replacing the Bracket on the MegaRAID SAS 9361-24i RAID Controller
Figure 4
. Heat Sink Held in Place by Retaining Clips Attached by Bracket Screws
CAUTION: Do not move or rock the heat sink after you remove the bracket screws. Doing so
might damage the thermal interface material, which causes the controller to overheat
during operation. Damage to the heat sink or the interface material while changing
the bracket might void the controller warranty.
4.
Place the controller on top of the replacement bracket.
Place the controller on top of the
replacement bracket. Make sure to position the bracket so that the screw holes in the tabs are aligned
with the openings in the controller as shown in the following figure.
3_03575
