13
Chapter 2:
ES-2200T Operation
Figure 2-1: ES-2200T Front Panel
This section describes the front panel controls and indicators for the ES-2200T dual channel expansion system. The ES-
2200T is designed to operate any two DPS PC cards, including the Personal TBC III/IV, V-Scope and Routing
Switcher.
The SELECT button is used to address the individual cards installed in the UNIT 1 and UNIT 2 positions. After
selecting a desired unit, the front panel indicators will display the selected card parameters. The momentary push
button switches on the ES-2200T front panel are used to select the various operating modes. Pressing the appropriate
button (e.g., Video) and then rotating the shaft encoder knob performs changes to a mode setting (e.g., Video Level).
The bar graph display, located to the left of the shaft encoder, provides a relative measure of the selected setting.
The labels in red located directly above the ES-2200 front panel buttons represent V-Scope functions. The labels
located above the V-Scope labels in black represent the TBC card functions. The actual operation of the controls
depends on the combination of cards installed in the ES-2200 chassis. For example, if a TBC card was installed in
UNIT 1 and a V-Scope in UNIT 2, the labels in black would refer to UNIT 1 (TBC) functions and the red labels would
refer to UNIT 2 (V-Scope) functions.
If the ES-2200T you are operating has an 8-bit MicroSYNC installed in it, the front of the chassis will not reflect all the
MicroSYNC commands. Please refer to Figure 2-3 to see how those controls relate to the
ES-2200T’s controls.
SELECT TIMING INPUT FREEZE BALANCE PROC AMP
UNIT UNIT H-POS C F NTSC SVHS FRM/FLD TAKE RED BLUE VIDEO BLACK CHROMA HUE
1 2 FLAT LOW 1H 2H PK/VAR FREEZE NRM SUPER WAVFRM VECTOR OVERLAY SPLIT
REMOTE CONFIGURE STROBE FILM MD STORE RECALL PREVIOUS UNITY
VRT BLKG MONO GEN MD BURST BLK OUT GEN TERM CMB FLTR HOT SW
5 MAX
4 +
3 UNITY
2 -
1 MIN
ES-2200T
DUAL TBC
EXPANSION SYSTEM
V-SCOPE CONTROLS
TBC CONFIGURATION
1
0
ON
POWER
