LBC-HDMI-T/R-WP User’s Manual
Link Bridge
TM
HDMI Wall Plate HDBaseT Transmission System
Broadata Technical Support, (800) 214-0222
8
2.0 SETUP
The BCI LBC HDBaseT Extender Series units are used in pairs. One
LBC-HDMI-T-WP transmitter unit is located at the near-end (source)
and connected through a single category cable, to the LBC-HDMI-T-WP
receiver shown below and located at the far-end (sink) of the link.
Figure 2-1 depicts a typical installation for the LBC-HDMI-T/R-WP pair.
2.1 Mounting
Before installing the units into your housing, make sure there is
enough space to pull and connect both the electrical and category
cables without stressing them beyond the manufacturer’s
limitations (also known as the minimum bend radius).
2.2 Cabling and Connectors
In order to setup the LBC-HDMI-T/R-WP properly, make sure
to observe the following instructions when installing the proper
cables. The LBC-HDMI-T/R-WP requires two parts to the
cabling setup, the video signal and the transmission connections.
Figure 2-1
LBC-HDMI-T-WP with LBC-HDMI-R-WP Transmission Pair
