LBC-HDMI-T/R-WP User’s Manual
Link Bridge
TM
HDMI Wall Plate HDBaseT Transmission System
Broadata Technical Support, (800) 214-0222
14
4.0 MAINTENANCE AND TROUBLESHOOTING
4.1 Maintenance
There is no operator maintenance other then keeping the units
clean. However, observe the following light indicators to make
sure that the unit is working properly:
4.2 Troubleshooting
If the LBC-HDMI-T/R-WP units do not operate properly after
installation, check for possible cable breaks, loose connections,
and incorrect cable connections. If problems persist that may
be fiber related, contact BCI at 1-800-214-0222 for further
assistance.
For electrical problems, perform the following troubleshooting
procedures:
1.
If the POWER indicator is OFF, check for the following:
a.
The line cord is plugged into the unit and your outlet
has power.
2.
If the POWER indicator is ON, but the Link indicator is
OFF, check for the following:
a.
Make sure the appropriate cables are being used.
b.
Cable and cable connectors are not broken.
c.
For each unit, the transmit (TX) cable is connected to
the other unit’s receiver (RX).
3.
If the POWER indicator and Link indicator are ON, but
the channels are not operating, then:
a.
Check to see that the attached user equipment is turned
on.
b.
Both ends of the link are connected to the corresponding
equipment and to the same corresponding channel port.
