British Fires EF40-63B, Installation & User'S Instructions

Page: 37 / 48

// 13.0 SAFETY CUT-OUT SYSTEM // 14.0 CLEANING AND MAINTENANCE
This appliance has a non-self-
resetting overheat protection
device (thermal cut-out) which will
activate if the air inlets or outlets
are obstructed. For safety
reasons the fire will NOT switch
on again automatically.
The following procedure must be
carried out before the fire can be
operated again:
1)
Switch OFF the appliance at the
wall socket
or outlet. Leave the
fire OFF for a period of no less
than 10 minutes, ensuring all
obstructions are removed.
2)
Switch the appliance to ON at
the wall.
3) Ensure the appliance is turned
ON at the ON/OFF switches.
NOTE: During the cut-out test the fire will
automatically display ‘88’.
If the fire fails to operate correctly,
repeat steps one and two. If an
attempt to switch on the appliance
is made before the safety cut-out
has reset, the appliance may
cut-out for a further period of time.
If the sequence has been followed
correctly and the appliance still
fails to function, check the fuse
in the wall outlet. If this is not
the cause, call an electrician or
maintenance engineer.
NOTE: The flame-effect will remain operational if
the cut-out is activated and only the fan heater
is prevented from working.
Cleaning:
For general cleaning use a
soft clean duster – never use
harsh abrasive or cleaners. The
glass panels should be cleaned
carefully with a soft cloth.
Remove the front facing glass
pane in order to clean the inside
of the pane. Please refer to
section 8.1 to do this.
Except for periodic cleaning of
dust, there are no specific
requirements for care, other than
regular cleaning of the general
appliance. A wipe with a dry cloth
is normally sufficient. DO NOT
use abrasive cleaners as they
can damage the finish. Make sure
the heater outlet and inlet grille
(located on the top, front, centre
of the appliance) is kept clear of
dust, pet hair and other airborne
household matter. These should
be vacuum cleaned periodically
using a brush attachment. The
LED light strips are designed and
tested to last 20,000 hours.
Handset Battery Replacement
Battery Requirements:
Two (2) AAA 1.5V
1) Remove the battery cover and
the used batteries from the
back of the remote control.
2) Insert the two replacement
batteries the correct
way into the battery
holder — making sure the
batteries are firmly seated.
3) Then insert the battery cover
back into position.
4)
You will then need to pair the
remote to the appliance. Please
refer to section 11.0 Pairing
The Remote Control.
If in doubt consult a qualified electrician. Refer to
Section 3.0 Appliance Data for fuse specification.
Excluding fuses, use only genuine manufacturers
spare parts available from your supplier.
// CAUTION:
Always disconnect the appliance from the mains supply outlet socket
before undertaking any cleaning or maintenance!
//
34 © 2022 British Fires