Briteq STAGE BEAMER RGB, Manual, Page: 15 / 22

13 3 DISPLAY PANEL OPERATION
CAL1
Enter the CAL1 to select white color of different color temperature.
There are 11 pre-programmed White colors can be edited by using Red ,
Green , Blue
3.11 WHITES CALIBRATION
CAL2
Enter the CAL2 to adjust the RGB parameter to make different whites.
CAL2
When the new setting is activated, the DMX controller choose
RGB = 255,255,255, the white color will be made by the actual RGB values on
the
.
3.12 RGB CALIBRATION
3.13 ACTIVATE THE PASSWORD
KEY
Enter the KEY mode to select whether the access password is on or off.
When the fixture is set as PASS ON , after 30 seconds or turn on the fixture
next time, the fixture will need an access password to enter the display menu
control.
Note: The factory access password is UP + DOWN + UP + DOWN ,
then press ENTER to confirm the access.
Enter Dim to select dimmer mode and dimmer speed. When DIMMER is
set to Off , then RGBW and MASTER DIMMER are linear. The Dim 1/2/3/4
are speed modes of the non linear dimmer , Dim1 is the faster, while
Dim4 is the slowest.
The factory default setting is Dim4 .
&
2009.11.10