ENGLISH
USER MANUAL
BRITEQ
®
7/9
EXPO CANNON
•
Factory:
standard factory settings.
•
USER x:
you can adapt the factory settings and save the new parameters as your personal USER-
settings.
•
Press the ENTER button:
•
Factory was selected:
the display shows “LOAD”
•
Press the ENTER button and u
se ▲/▼ buttons to confirm YES / NO
•
Press the ENTER button to confirm.
•
USER Def. was selected:
the display shows “LOAD”
•
Use
▲/▼ buttons to select LOAD / SAVE
•
Press the ENTER button and u
se ▲/▼ buttons to confirm YES / NO
•
Press the ENTER button to confirm.
•
SAVE was selected:
the current settings of the setup menu are saved to memory.
•
LOAD was selected:
the previously saved settings are loaded.
Set of Factory default settings:
PARAMETER name
FACTORY defaults
USER defaults
CHANNEL mode
2CH (D+S)
Current setting in the menu
NO DMX mode
Freeze
Current setting in the menu
DIM Curve
Square
Current setting in the menu
Dimmer Speed
100 (440ms)
Current setting in the menu
AUTO LOCK Menu
OFF
Current setting in the menu
FIRMWARE
Used to show the current version of the firmware.
•
Press the MENU button until the FIRMWARE is showing on the display.
LED TEMP
Shows the actual temperature of the LEDs.
•
Press the ▲/▼ buttons until the desired function is showing on the display.
•
Press the ENTER button: the LED temperature is shown.
The firmware of this unit can be upgraded using a special upgrade tool with Windows
®
software. (separately
available from Briteq).
Each time the projector is switched on, the display shows
UPDATE Wait ….: while this message shows on
the display you can start the update using our special upgrade tool. More information about this can be found
in the user manual of the upgrade tool and / or our website:
www.briteq-lighting.com
RDM FUNCTIONS / REMOTE SETUP
RDM
means “
R
emote
D
evice
M
anagement”. This projector works with a brief set of RDM-functions which
means that it can setup a bi-directional communication with an RDM-compatible DMX-controller. Some of
these functions are briefly explained below, others will be added in the future.
•
The DMX-
controller sends out a “discovery command”, all RDM devices respond and send their unique
device ID.
•
The DMX-controller asks each RDM device for some basic data so it knows which devices are connected.
The projector will respond:
•
Device name:
EXPO CANNON
•
Manufacturer:
Briteq
®
•
Sensors:
actual LED temperature
•
Service hours:
total used hours since 1
st
use.
•
Firmware:
x.x.x.x
firmware version of the projector
•
DMX address:
xxx
current DMX start address of the projector
•
DMX footprint:
xx
number of DMX-channels used by the projector
•
Personality:
xx
current personality or DMX-working mode used by the projectors
•
The DMX-controller can send certain commands to each RDM device which allow remote setup of the
units. Thanks to this the projectors can be setup remotely.
