ENGLISH
OPERATION MANUAL
BRITEQ
®
4/11
BT-NONABEAM
9. M10-SUSPENSION POINTS:
several points can be used to install the projectors in custom frames.
Attention: the maximum installation depth for the M10 bolts is 20mm!
10. FRONT PANELS:
the projector comes with 3 different front panels that can be used for different
applications:
•
BLACK FRONT: (installed as standard)
this semi-light translucent panel looks black while not lit and
can light up in different colors (RGB glow effect). Perfect for stage applications!
•
WHITE FRONT:
this semi-light translucent panel looks white while not lit and can light up in different
colors. Advantage: the RGB-glow effect will be much more powerful compared to the black panel.
•
MIRROR FRONT:
the front of the projector looks like a mirror and can be used to reflect
(laser)beams for extra effects. The RGB glow effect is similar to that of the black front.
11. PANEL SCREWS:
these M4 screws are used to keep the front panel in place. Simply remove the
screws and slide the FRONT PANEL aside to replace it.
Attention: To prevent the front panel from cracking, do not over-tighten the screws or use an electric
screwdriver.
12. ANTI-GLARE LOUVERS:
these ensure a tight beam and prevent glare. Black louvers are installed as
standard, a set of 9 gold colored louvers (order code: 05415) is optionally available. Simply remove the
front panel (10) to access the screws that keep the louvers in place.
SETUP MENU:
The setup menu of this projector has been deliberately kept very simple to allow quick installation with less
risk of incorrect settings. In addition, a number of important settings are made via a DMX control channel.
DISPLAY
DESCRIPTION
CH:
ccc
xxx (yyy)
DMX-address setting
(Also standard display)
CH. MODE
xxCH
Channel mode
PIX ORDER
A (std)
Pixel order (A,B,C,D numbering)
CURVE
SQUARE
CURVE select
FACTORY
RESET
FACTORY RESET
FAN
AUTO
FAN mode
PIX:
xxx°C
RGB:
xxx°C
TEMPERATURE display
FIRMWARE
Vx,xx
FIRMWARE display
•
Press the MENU button to enter the setup menu.
•
Use the
▼/▲ buttons to browse the menu until the required function shows up.
•
Select the function with the ENTER button.
•
Use
▼/▲ buttons to change the values.
•
Press the ENTER button to confirm the selected value.
DMX ADDR
Used to set the desired DMX-address.
•
On the standard display, press the ENTER button: the start address blinks.
•
Use
▼/▲ buttons to select the desired DMX512 address. The last occupied DMX-address is also shown:
makes it easier to set the address of the next unit in the chain.
•
Once the correct address shows on the display, press the ENTER button to save it.
Remark: on RDM-compatible controllers this option can also be remotely set.
