ENGLISH
OPERATION MANUAL
BRITEQ
®
10/11
BT-NONABEAM
13
29
45
109-114
No function
115-120
PIXEL ORDER: A (standard 0°)
121-126
PIXEL ORDER: B (rotated over 180°)
127-132
PIXEL ORDER: C (rotated over +90°)
133-138
PIXEL ORDER: D (rotated over -90°)
139-144
No function
145-150
FAN AUTO: temperature controlled
151-156
FAN FULL: always on
157-162
No function
163-168
LINEAR dimmer curve
169-174
SQUARE dimmer curve
175-180
INVERSE SQUARE dimmer curve
181-186
S-CURVE dimmer curve
187-192
No function
193-198
LOAD FACTORY settings to SETUP MENU
199-255
No function
Remark: All functions in the control channel become active after 3 seconds.
To avoid accidents “LOAD FACTORY settings” becomes active after 6 seconds.
MAINTENANCE
•
Make sure the area below the installation place is free from unwanted persons during servicing.
•
Switch off the unit, unplug the mains cable and wait until the unit has been cooled down.
During inspection the following points should be checked:
•
All screws used for installing the device and any of its parts should be tightly fastened and may not be
corroded.
•
Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any
deformation.
•
When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced.
•
The mains cables must be in impeccable condition and should be replaced immediately when even a
small problem is detected.
•
In order to protect the device from overheat the cooling fans (if any) and ventilation openings should be
cleaned monthly.
•
The interior of the device should be cleaned annually using a vacuum cleaner or air-jet.
•
The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to
optimize light output. Cleaning frequency depends on the environment in which the fixture operates: damp,
smoky or particularly dirty surroundings
can cause greater accumulation of dirt on the unit’s optics.
•
Clean with a soft cloth using normal glass cleaning products.
•
Always dry the parts carefully.
Attention: We strongly recommend internal cleaning to be carried out by qualified personnel!
